EVAL_IMD700A_FOC_3SH BSP

Overview

The EVAL_IMD700A_FOC_3SH houses the IMD701A-Q064x128 three-phase smart motor driver IC with on board debugger.
Note: Programming this kit requires installing SEGGER J-Link software

To use code from the BSP, simply include a reference to cybsp.h.

Features

Kit Features:

• IMD701A three-phase smart motor driver IC with integrated XMC1404 (ARM® Cortex®-M0 based) Microcontroller
• IQE013N04LM6 (OptiMOS™ 6 40 V/1.5 mΩ 3x3 corner gate, source down)
• On board Debugger for downloading and debugging of application code
• Two user LEDs connected to GPIO P4.7, P4.8
• Speed POT to set speed reference of motor connected to analog input P2.5
• 8-pin XMC™ MCU Debug Connector to external debugger
• 5-pin HALL connector inputs for motor position feedback connected to GPIO P4.1, P4.2, P4.3
• On board temperature sensor connected to analog input P2.4

Kit Contents:

• EVAL_IMD700A_FOC_3SH evaluation board

BSP Configuration

The BSP has a few hooks that allow its behavior to be configured. Some of these items are enabled by default while others must be explicitly enabled. Items enabled by default are specified in the EVAL_IMD700A_FOC_3SH.mk file. The items that are enabled can be changed by creating a custom BSP or by editing the application makefile.

Components:

• Device specific category reference (e.g.: CAT1) - This component, enabled by default, pulls in any device specific code for this board.

Defines:

• CYBSP_WIFI_CAPABLE - This define, disabled by default, causes the BSP to initialize the interface to an onboard wireless chip if it has one.
• CY_USING_HAL - This define, enabled by default, specifies that the HAL is intended to be used by the application. This will cause the BSP to include the applicable header file and to initialize the system level drivers.
• CYBSP_CUSTOM_SYSCLK_PM_CALLBACK - This define, disabled by default, causes the BSP to skip registering its default SysClk Power Management callback, if any, and instead to invoke the application-defined function cybsp_register_custom_sysclk_pm_callback to register an application-specific callback.

See the BSP Setttings for additional board specific configuration settings.

API Reference Manual

The EVAL_IMD700A_FOC_3SH Board Support Package provides a set of APIs to configure, initialize and use the board resources.

See the BSP API Reference Manual for the complete list of the provided interfaces.

More information

• EVAL_IMD700A_FOC_3SH BSP API Reference Manual
• EVAL_IMD700A_FOC_3SH Documentation
• Cypress Semiconductor, an Infineon Technologies Company
• Infineon GitHub
• ModusToolbox™

---

© Cypress Semiconductor Corporation (an Infineon company) or an affiliate of Cypress Semiconductor Corporation, 2019-2024.