KIT_XMC1400_DC_V1 BSP

Overview

The XMC1400 Drive Card houses the XMC1402 Microcontroller, a power board connector, a set of position interface circuits with hall and encoder connectors, a USIC interface and an isolated on-board debug interface. The board along with a three phase inverter demonstrates the capabilities of the XMC1402. The main use case for this board is to demonstrate the motor control features of XMC1402 device including tool chain. The focus is safe operation under evaluation conditions. The board is neither cost nor size optimized and does not serve as a reference design.
Note: Programming this kit requires installing SEGGER J-Link software

To use code from the BSP, simply include a reference to cybsp.h.

Features

Kit Features:

• XMC1402 Microcontroller in TSSOP-38 with 200KB Flash and full peripheral set of XMC1400 series
• On board Debugger for downloading and debugging of application code
• Virtual COM port for UART communication with terminal program e.g. Hyperterminal

Kit Contents:

• KIT_XMC1400_DC_V1 drive card

BSP Configuration

The BSP has a few hooks that allow its behavior to be configured. Some of these items are enabled by default while others must be explicitly enabled. Items enabled by default are specified in the KIT_XMC1400_DC_V1.mk file. The items that are enabled can be changed by creating a custom BSP or by editing the application makefile.

Components:

• Device specific category reference (e.g.: CAT1) - This component, enabled by default, pulls in any device specific code for this board.

Defines:

• CYBSP_WIFI_CAPABLE - This define, disabled by default, causes the BSP to initialize the interface to an onboard wireless chip if it has one.
• CY_USING_HAL - This define, enabled by default, specifies that the HAL is intended to be used by the application. This will cause the BSP to include the applicable header file and to initialize the system level drivers.
• CYBSP_CUSTOM_SYSCLK_PM_CALLBACK - This define, disabled by default, causes the BSP to skip registering its default SysClk Power Management callback, if any, and instead to invoke the application-defined function cybsp_register_custom_sysclk_pm_callback to register an application-specific callback.

See the BSP Setttings for additional board specific configuration settings.

API Reference Manual

The KIT_XMC1400_DC_V1 Board Support Package provides a set of APIs to configure, initialize and use the board resources.

See the BSP API Reference Manual for the complete list of the provided interfaces.

More information

• KIT_XMC1400_DC_V1 BSP API Reference Manual
• KIT_XMC1400_DC_V1 Documentation
• Cypress Semiconductor, an Infineon Technologies Company
• Infineon GitHub
• ModusToolbox™

---

© Cypress Semiconductor Corporation (an Infineon company) or an affiliate of Cypress Semiconductor Corporation, 2019-2022.